I set up my y-axis rotary system and when I went back to normal mode I keep getting a “flame detector inactive. Luminosity too high.” alarm. I tried disabling the flame detector by &261=0, but I get the same alarm. What do I do to get past this?
JohnJohn
(John Johnson)
April 29, 2022, 10:35pm
2
Ortur has provided a firmware update. I believe this will resolve it.
Is your Pro 2 an S1 or an S2?
Current Advisories :
15-Dec-21 - Status Final - Strongly Recommended
Firmware Update
Ortur Laser Master 2 Pro S1 - 1.75 Firmware Update
Ortur Laser Master 2 Pro S2 - 1.87 Firmware Update
https://ortur.tech/latest-firmware/#olm2pros2
Ortur Laser Master 2 Pro 1.5 Series update should be dropping next days too.
OLM2 1.4 series will also recieve a firmware update, its ready we just trying to pace ourselfs. 1.42 will launch with only 2 small housekeeping changes.
Few important aspects in the …
system
(system)
Closed
May 29, 2022, 10:35pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.