Frame indication

[fab1926 (Frank Alan Britch)]

How do I get a light to show the outline of the frame button.
I read one reply that said press the shift key whilst pressing the fram button and press the fire at less than 3% this I can not find can anybody help me?

[LaserWillie (Willy)]

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …

[fab1926 (Frank Alan Britch)]

Thank you very much it worked!, but I must have pressed something after and on rebooting I don’t have a MOVE box. How do I get it back?

[LaserWillie (Willy)]

Window> make sure there’s a checkbox next to “Move” or reset to default.

Please mark it as “solved”

[fab1926 (Frank Alan Britch)]

Thank you. OK now. I didn’t think of looking in there.

[LaserWillie (Willy)]

LMAO, please mark in my comment, not yours that it solved it for you.