Hi there When I attempt to run engravings using my OMTech 30W laser w/ a Cloudray Rotary, along every “split” there is a noticeable misalignment. I’ve ensured that my workpiece is square to the laser head, but that didn’t change the issue. Basically, along any “split” in the job, there is a large …

So try this: Diameter 81.04 circumference=254.594 steps= 12800 so for each step surface moves 0.02 (0.0198) can’t move half that, can’t move 1-1/2 times that, SO… Try split size as a multiple of 0.02 (0.0198), like 0.02, 0.40, 1.98, and line intervals of 0.02, 0.01, 0.04, like that. If you have …

Galvo Rotary Axis Split size aliasing / misaligned

LightBurn Software Questions

Albroswift (Al Fernandez) March 13, 2024, 12:09am 2

Take a look at my reply about 3 down in this thread. I think your split is too large, I would be less then 1mm for that sized cup. If you dial your settings in you can loose the overlap as well.