How do you restart

[Three2day (GABRIEL TAFOYA)]

Laser stops on routine due to alarm lockout. Resetting starts the burn from the beginning, How do you restart from where the stall left off?

[berainlb (PY)]

Check the previous writeup and see if it works for you.

Windows restarted during job. How to continue job?

If it’s an image and without knowing anything more about your project your best bet may be to use the “Start Here” feature in the Preview simulation tool. You can use the slider control to move to the point where the job failed and then use “Start Here” to resume at that point. [image] Note that you can use up or down arrows to make very fine tuned adjustments to the progress bar. It will move very slowly so you may not notice movement immediately. Similarly, you can use PgUp and PgDn keys t…

I think more importantly, though, you need to sort out the alarm situation.