JessN
January 6, 2025, 10:23pm
2
Do the wings show up if you rotate your image? I wonder if you need to enable the special engraving mode mentioned in this forum post: Not engraving thin lines perpendicular to scanning - #2 by Stroonzo
If this issue also shows up in RDworks, you may want to confirm that your power supply is wired correctly. This user was able to achieve tiny engravings like yours by switching to PWM-signal instead of analog:
Hi, i think i found the issue.
I bought my machine recently and i’m new to lasers so it took me a while to figure this out.
i tried resetting all settings in lightburn, reïnstalling etc → same issue.
i then tried RDworks (came with the machine) → same issue.
so it had to be a machine issue.
i tried to tightening belts, lube guide rails etc, no change
i realigned the laser again, it had not deviated (visibly) from when the machine was just bought.
then i turned my attention to the powersup…