apologies if this question has already been asked. I found my CNC stopped at a specific point during an engraving job. I don’t know how to resume the work in Millmage by specifying a particular point; I can do it with other, more basic software by turning the machine off and on and entering the ex…

I will if you excuse my poor English. Similar to how you do it with s GCode sender. If you know the point where it stopped, you can save the project as GCode. Then remove the unwanted part with a text editor. You can then use MillMage as a GCode sender and run the remaining part of the file. If yo…

Hi @cupeppe Just to add to @MikeyH suggestion: be careful when editing GCode to resume a job. Removing earlier lines can also remove important setup commands, including spindle control, positioning modes, and safe Z movements. Before restarting, make sure your workpiece hasn’t moved and your X/Y/Z…

[image] Dominic: Just to add to @MikeyH suggestion: be careful when editing GCode to resume a job. Removing earlier lines can also remove important setup commands, including spindle control, positioning modes, and safe Z movements. Before restarting, make sure your workpiece hasn’t moved and yo…

[image] cupeppe: I’ll attach some photos if you’d like. Please do. There is Finished Creations section that is just perfect for it.

Thanks, done. [image] Bas-relief or 2.5D engraving Finished Creations [IMG_6668] [IMG_6667] [IMG_6665] I’m sharing my very first experiments with the roughing and finishing functions of Millmage Pro. [IMG_6644] [IMG_6646]

LightBurn Software Forum

I'm picking up from here

MillMage Software Questions

cupeppe (cupeppe) September 29, 2026, 9:21pm 7

Thanks, done.