Invalid code ID:66

I have received an “error: invalid gcode ID:66”. I was working in LightBurn, finished one project and was starting another when I received this error. I had received the same error about one and a half weeks ago, my husband had to undo something with the drives and start again. Is this common?? Will we have to reconfigure or uninstall/reinstall that often? I still have 270 days on my license.

Check this Topic:

Try enabling “DTR Signal” in Edit->Device Settings to see if that changes behavior.

Thank you so much! I ended up disconnecting the usb while the laser and lightburn were both running and let it sit for 30 seconds, then connected the usb and it worked.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.