Is, or will, the Genmitsu Z5-1 fiber laser be compatible with Lightburn?

I am new to LightBurn and the laser engraving community as a whole.
I have a Genmitsu Z5-1 fiber laser and would like to know if this laser is compatible with LightBurn. If so, can someone please point me in the direction on where the instructions are located?
If not, can someone point me in the direction to request this be added to LightBurn?
I am looking forward to being a contributing member of these forums by sharing ideas and helping others.
Thank you.

That laser runs a BSL controller - which is on our radar for support in the future, but we do not have an estimate available as to when that will be.

Thank you. I will be keeping an eye out for when this laser is supported.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.