I followed the guide carefully, but the issue happens right after writing the LightBurn Bridge image to the SD card and inserting it into the Raspberry Pi 3B+. The Raspberry Pi does not boot properly. Here’s exactly what happens: The red LED stays on. The green LED blinks 4 times slowly and then …

Hi everyone, I wanted to share my experience and solution in case it helps anyone else facing the same issue. The Problem: I tried to install LightBurn Bridge on a Raspberry Pi 3B+ following the official guide using Pi Imager to flash the SD card. However, after inserting the card and powering on …

Issue Installing LightBurn Bridge on Raspberry Pi 3B+

LightBurn Hardware Compatibility LightBurn Bridge

berainlb (PY) April 10, 2025, 8:07pm 4

There’s not a clean resolution but this Topic covers some issues with 3B+.