Smaggy
(Richard C Mobbs)
May 24, 2019, 11:09pm
1
I used the software that came with it and it works ok.
Just set up with the wizard, but the movement controls are backwards. What should I do?
raykholo
(Ray Kholodovsky)
May 25, 2019, 1:19am
2
Please start by helping us to help you:
Folks,
When asking for support for LightBurn via this forum, email or anywhere else, please keep the following tips in mind for the fastest and most helpful answers.
Please provide these details:
What machine do you have?
What controller does it have , and what firmware it is running?
Are you running the latest version of LightBurn?
Is the issue new, or has it happened before? What kind of computer is it, and what Operating System is it running?
Please note these things:
Please speak in co…
You’ve likely chosen the wrong origin - GRBL in LightBurn uses front / left as the origin. If you picked rear / right it would reverse everything. You can change this in the device settings.
system
(system)
Closed
June 8, 2019, 3:15am
4
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.