K50 fires too late and ends too early while engraving

[RHO (Rainer Hoermann)]

Here are the other users and their links to the similar issues (was not allowed to put more in just 1 post):

@bummer

Problem with Overscanning but no ability to adjust

I posted on FB New to Laser Engraving but didn’t get an answer. My engraving goes outside of my boundary lines and someone suggested running the Scanning Offset Adjustment, which I did and it helped. But as you can see from the photo, even though my lines are now even, the laser seems to be firing too early and ending too late to have the engrave stay within the limits of the object boundary. I asked on FB if there was a setting that could tell the laser to delay starting the engrave and to e…

@Purdon

Trouble after setting scanning offset adjustment

Hi new to lasers have just got a Chinese laser trying to go through all the calibration and set up I have been trying to do the scanning offset adjustment I can get it so lines are perfectly lined up on x axis but then the scan lines start late Finnish early in comparison to the line around outside [image] [image] [image]

And also here the other pictures with different initial offsets:

Initial offset -0mm:

Initial offset +0,5mm:

Sorry for splitting the info in to posts, but that was due to the restriction of bloody beginners (like me) in the lightburn forum

BR,
Rainer