Keep getting Error 24

[jkwilborn (Jack Wilborn)]

Ortur Laser Master 2 Pro "Error 24" stopping progress mid burn

Hey there, New to the forums. I’m getting Error:24 “Two G-code commands that both require the use of the XYZ axis words were detected in the block”. I’ve read quite a bit of the forums and other web sites, I’ve seen all the suggestion to change the usb cable, ground the chassis, new power supply, stop the shaking of the table. But my problem is I created this file “clock_1.lbrn2” file for a clock face in LightBurn 1.0.02 and using it on my Ortur Laser Master2 Pro with FW 1.55. and it fails ev…