Hi, I’ve changed the controller on my G.Weike 6090 from the original Leetro MPC6525 to a Ruida RDC6442S so I could get rid of Lasercut5.3 and use Lightburn instead. I connected LASER DA from the Leetro to LPWM1 on the Ruida and LASER LAS to L-On1. I have laser1 in the machine settings enabled, la…

[image] bernieke: measuring 1V on the PWM when cutting at 25% It should be 25% of 5 or 1.25V… But that’s probably ok… at least until we look a bit… It’s in a workable range… Might want to unplug the controls lines to the lps and see if the controller by itself will show a high on the LOn-1…

Laser firing both during move and cut operations

LightBurn Hardware Compatibility Ruida controllers

jkwilborn (Jack Wilborn) April 2, 2023, 4:01pm 12

Welcome aboard …

I suggest you start a new thread with your issue. This thread has already been solved.

This will help you provide the information for us to help you.

See you over there