Laser not firing up when clicking the show position

[Assad (Assadh Mohamed)]

am using laser master 2 , 15W

[LightBurn (Oz)]

‘Show Position’ draws a crosshair on screen to show where the laser head is. It doesn’t fire the laser.

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …

[Assad (Assadh Mohamed)]

Thank You!. Appreciate the support.