Laser print is having scratch marks while moving over white space

[berainlb (PY)]

Read through this and see if it applies to your situation.

Issue with flood fill alignment and "dragging" traversal lines

My hardware is an Ender 3 Pro with Marlin 0.0.6 fir.ware and a Comgrow 5 Compressed FAC laser. I’m really struggling with a couple of issues and could use some input from the experts! First, when I’m not using flood fill, the traversal l lines tend to “drag” as if the laser is not being turned on and off quickly enough at the end of a mark. It does this even at very low speeds (4mm/sec). A simple square inside of a square fill cut actually blurs the inside square so much you can hardly see it. …

If not, can you detail out how your situation is different?