Laser Sculfun S9 busy

[alcantaragarciaj (Multicast)]

@misken

What did you do to make it being busy? You have to have pressed some button to make it move or something. This shouldn’t come up if you only start the laser?
You might check if you enabled “auto home on startup” in device settings. Then it tries to home at the beginning. This laser has no limit switches and this does not work.
Maybe additionally, take a look at this guide

I was configuring the equipment setting, and when I gave it Save, it did not finish recording, it hung, from there it presen

ts this problem, is there any way to reset the laser to its default values?