FFS. Since of today i’m facing the same issue with my Orut Laser Master 2.
@LightBurn you said
“As for the “many other posts”, I’d bet that if you look closer you’ll see that nearly all of them are from Ortur laser owners. Those systems have no grounding and customized firmware, both of which seem to be contributing to the issue.”
so what’s the solution?
EDIT: As i found in this post (Engraving a picture, laser shuts down in about 3 to 4 minutes - #41 by LightBurn) the Ortur Lasers are not grounded and that is the reason for the laser to suddenly stop on a job.
Anyone knows how to ground it?