My laser stops in the middle of engraving, saying target buffer size found, how do I correct this setting?
Same here, does not look as though you have had any help
Are you getting additional messages in that stream? We have seen many posts about static build-up that can cause the control board for these systems to reset, mid-job. Please provide a screen grab of the entire ‘Console’ output for review.
This does not explain what the exact issue you are observing. Simply saying “same here” leaves a lot out. You have not said what firmware you use, how you have this connected, what OS, basically, everything we need to know to offer suggestions for resolution.
I was not asking for help, I was commenting on the OPs post that I was suffering the same problem.
Changing orientation to the X axis sorted mine out