LightBurn Software Forum

Laser Stops about 1/3 way through a job

LightBurn Software Questions

Rick (Technical Evangelist) July 7, 2021, 7:16pm 2

ORTUR LASER MASTER 2 - Service Notice - Grounding Ortur Lasers

ORTUR LASER MASTER 2 - Service Notice - Grounding Full Documentation: http://ortur.tech/orturgrounding Some users have been reporting and experiencing Static Electricity build up in their machines while in use, especially on raster engraving operations. This build up of Static Electricity can become severe to the point that its discharge – via the 12v rail – can cause the motherboard to reset. Therefore causing interrupted engraving operations (Alarm 3/Connection Lost errors). In extreme cir…

ORTUR LASER MASTER series v1.4 Firmware Release Ortur Lasers

WINDOWS Computers ONLY - Do not Attempt on MAC/LINUX Change Log: V1.40 Release Date: 04 January 2021 Fixes: Pause/Resume issue been corrected. Laser Pause/Resume functions now work as expected; Corrected False positive [Check Limits] on Pro Motherboards (RJ connector/Vertical buttons boards); Improvements: GRBL Core Upgrade from 1.1f to 1.1h; Optimization of USB Driver Library. Attempt to address disconect issues/Alarm 3; Fan Delay ShutDown Function. Fan will Remain on from 30 to 120 sec…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled