LightBurn Software Forum

Laser stops engraving mid job

LightBurn Hardware Compatibility GRBL

LightBurn (Oz) March 26, 2021, 5:54pm 5

ORTUR LASER MASTER 2 - Service Notice - Grounding Ortur Lasers

ORTUR LASER MASTER 2 - Service Notice - Grounding Full Documentation: http://ortur.tech/orturgrounding Some users have been reporting and experiencing Static Electricity build up in their machines while in use, especially on raster engraving operations. This build up of Static Electricity can become severe to the point that its discharge – via the 12v rail – can cause the motherboard to reset. Therefore causing interrupted engraving operations (Alarm 3/Connection Lost errors). In extreme cir…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled