Hi gang. Newbie here.
I have the ORTUR Master Laser 2 Pro S2 (LU2-4-SF)
I have successfully engraved on walnut a few times. I think I may have changed something when attempting to install the rotary roller.
In any new program when I attempt the “Frame” the job, the laser moves to the start point, runs across the bottom, but when it starts going up the right side, it stops halfway.
Anyone?
I’m able to start the laser and the burn, but it stops at aprrox the 20% mark.
Thx
bnd
Are you using Absolute Coords?
If that’s not it a screenshot and photo of your 20% complete job would be helpful.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.