How can I carve letters and words, I can’t find a way, even if it’s in a straight line without the ups and downs that v-bits do.

if your meaning V carve thats not avaliable yet I carve using a profile operation at present in MM, set cut to along line, finding the right text is the key at present , i use a very narrow text to get best results as you can see bottom 3 fonts are not clean done with a 60deg at 3 and 4 mm top…

I would use a Profile operation and a cutter with the tip geometry you’re looking for: Profile - MillMage Documentation You could also try a fluting operation: https://www.youtube.com/shorts/oAH1ZOkyXvM

We also support single-line fonts (SHX fonts, which you can find on the forum, and TTF single line fonts available here: https://www.singlelinefonts.com/ ) Those would work with a narrow end, ball, or V mill, as a profile on the line.

cheers for the link , that has never popped up when ive been searching for decent single line font hence using a fine line

To assist with :backhand_index_pointing_up:: [image] SHX Font Collection LightBurn Software Questions Now we have SHX Fonts available I have put together 44 single line fonts into a folder. I’m happy to make the folder of fonts available (dropbox link) if t…

A nice selection of free single line fonts I put together in my profile here: Single line | Collection | FontSpace :wink:

Letters - Words

MillMage Software Questions

Rick (Technical Evangelist) May 7, 2026, 10:36pm 7

To assist with :