Light burn tells me I am out of bounds every time I use current setting and center position

[berainlb (PY)]

This is addressing a different but similar question and likely applies to you:

Confused positioning?

Can you confirm these 3 conditions: You are homing the laser at the start of the session You are not moving the laser head by hand, using jogging controls exclusively You are using Absolute Coords as Start From mode in Laser window If any of these conditions are not met, try adhering to them. Does that change behavior?

I suggest you also take some time to understand the various Start from modes in LightBurn:
Understanding The Different Start From Modes In LightBurn - YouTube