Lightburn Bridge - Laser timeout error

[jkwilborn (Jack Wilborn)]

I lost two PI’s to thunderstorms and with covid, they became to expensive.

I’ve probably forgotten most of this, but read through this link and see if it helps… If not sing out.

Bridge connects to PC, but shows No Laser Connected - Laser Timeout Error

Hi, I have a RDC6445S 50W CO2 machine. I flashed the Bridge image to a Pi4 that I used as a NAS a short while ago, and I can connect it to the network fine. After setting up the machine IP to the default 10.0.3.3 and connecting it to the Bridge through Ethernet though, the Bridge Discovery Wizard says No Laser Connected. [image] [image] [image] Here’s the Bridge status page and the relay log

@CraigLubbe

cannot workout what the username and password

Seems there wasn’t a password or it was the users password, but I thought you can sudo passwd. As far as I remember, it was so simple I forgot it…