LightBurn Bridge LightBurn Camera integration?

[kimcareey]

Maybe “Synchronous” mode works fine.

Lightburn baud rate and grbl

Try this steps Edit → Device settings or the Button on top Click baud rate drop down, change it. Click ok [image] I would think though a firmware update could allow a higher baud rate.

What is Buffered vs Synchronous Transfer Mode

For grbl controllers… but I doubt it’s limited to just these controllers. Can we get an explanation of how the data flow works through Lightburn. Does this affect engraving or just jogging? How does it work with DTR? Thanks!