I am trying to get lightburn to work for my fiber laser but when i try to look for my device it does not find it. When i check my device manager it shows up in a section called BJJCZ device as a laser mark control board (usb). My laser is a cloudray 60w jpt m7 mopa 300 x 300 fiber laser if this help…

[image] kimcop: it detected it, If you were successful finding the laser once, please explain why you are trying again? This is not needed and will not find again. Do you see the profile you first successfully made in ‘Laser’ window profile drop-down near the bottom, lower-right?

[image] grindaur: I then tried to find the drivers on LightBurn, what a joke. Welcome to the LightBurn forum, and thank you for reaching out - yet this comment is just rude and unneeded. We produce documentation where we cover this “driver” issue in great detail. [image]

This would be rude as you state but I NEVER got this screen. I have done the uninstall/reinstall the license twice over 4 hours, I have gotten the driver finally from the laser integrator (CloudRay) and STILL it is not recognized by your software even though Windows does recognize it. YES I did fo…

[image] grindaur: How do I confirm that my copy has upgraded to Galvo? [image]

[image] grindaur: but I NEVER got this screen. I got the screen when I executed the set up file on my Win 10 laptop. [2022-07-23 galvo driver]

Were you doing an upgrade or were you running the beta? I have yet to see any setup file from Lightburn.

[image] grindaur: Were you doing an upgrade or were you running the beta? To test it for myself I went to the folder where my downoads were and executed LightBurn-v1.2.00.exe I agreed to the windows warning to allow changes to be made to the hard drive. I agreed to the file path suggestions…

Thanks to all your help enable this ancient luddite to get his system up and running on lightburn. I do appologize for my snarkiness as i tend to get very frustrated when things do not work right out of the box. Again thanks to all. Now I just have to figure out how to remove the fumes from my en…

Had you not installed the version of the software that contained the galvo support? I replied to your email asking something along those lines, because that’s the only way I can come up with that you’d not be given the option to install the driver.

Have you tried the ‘Zadig’ method in the docs? LightBurn does work with Windows 7, but you might need to use the Zadig tool to do the driver swap. [image] Galvo Installation - LightBurn Software Documentation Better software for laser cutters.

LightBurn Software Forum

Lightburn for galvo not working

LightBurn Hardware Compatibility Galvo

galvo, mopa, bjjcz, jpt-source, cloudray-60w

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled