Lightburn ignores "optimize Z moves" setting version 9.21

Hi everyone.
As the title states, I have the same issue as Bklynghost in his post Machine ignores "optimize Z moves" setting. The software ignores the optimize Z moves and goes to zero between each cut even if the layers have the same Z-offset. The system is WIN 10. Controller is a Ruida 6332G connected over ethernet. I was able to pinpoint the version where the issue first appeared - 9.21 (and onwards). Version 9.20 works fine. For the moment we rolled back and are using 9.20.
I hope this helps. If you need any additional info, please let me know.

Thank you for reporting this. Investigating further… :slight_smile:

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.