Low profile Laser, Camera calibration

[ednisley]

@DonO

the height to the cover is 175mm

A recent discussion may give you some ideas:

Camera For Lightburn 700x500cm Z 20cm

Hello , I want to install a camera in my co2 laser , i’ve seen several videos with kinds of mounts on open doors . I want to install in under the door , but work with doors closed for security reasons. I’ve calculated that it would need to be 173 degrees horizontal and 157 degrees vertical . Did anybody install a camera that wide ? Does lightburn support cameras with 180 degrees, i cannot see them in the helper menus, and all of cameras suggested have distances that get out of my laser door. I …