Makerbase DLC32 V2.1 TTL Laser wiring

I got it all functioning properly. I just could straight upgrade to the latest firmware - I had to jump back to the 3rd release before I could then follow that upgrade to the latest release. Other than that it worked fine.

I actually really like this new board. I can increase or decrease speed or power at the machine while in the middle of a job without having to stop and start over again as I did with the previous controller; zeroing my axis’s is simpler; and I have the choice of a private or open remote session; IE, I connect to the machines private network to do remote work (but that disconnects me from my own network and internet), or I can connect to the IP of my machine on the primary network. It’s the same way my DSLR camera works for retrieving or operating the camera. Plus it’s slightly faster than my previous board, which shaves a couple minutes off long jobs. I’m glad I upgraded, and won’t hesitate to do so again in the future should I need to.

Anyway, I’m up and running and enjoying my laser again! And off I go to do it some more. Cheers!