Makerbase MKS DLC32 V2.1 controller doesn't respond!

What board did you have? Is this a custom build or you bought the MKS DLC32 as a replacement for a full laser system? If so, which one?

To confirm, these drivers are installed onto the MKS DLC32 board? If so, did you configure the drivers using the dip switches on the board specific to your TMC2208 as specified in the manual found here?

Which wires specifically? Please take photos and describe in detail. Nobody on the forum knows what you know about the situation so rely on you to provide all manner of detail.

will look now.#

okay them switches are set as the diagram I will send pictures now .

Thats the board what pictures next ?

Blockquote

2 wires that came with the tmc 2208 , The board that i have didnt have name on it because i tried to find it again

them 2 wires above came with the TMC 2208 the picture didn’t through with the text a second ago.

I have found the Original page i have my download on but trying work out which one is which…

What did you set the switches to for each X and Y?

Had the drivers already been installed or you just installed them?

Still not clear what you’re referring to here. Can you reupload the photo?

Which board are you referring to?

The board i broke i didn’t send you a picture of it , I can do ?

Yes. Please do.

Again, what is the history on this? Is this a custom build or this came with an original complete laser system? Really need to understand context here.

The control board is flashing lots of different colours like it would do working normal and the Console is telling me its doing the Job counting down the and the percentage of the laser is on just no movement from the laser head…

Its custom from a 3018 to a 500mm x 500mm it worked perfect till i broke the board last week was doing all sorts on it…

This is my broken board

Sorry i did find out what board was in the end it was a VIgo tech but couldnt find it again…

Do you have the original GRBL configuration from the Vigotec? Have you configured the settings on the MKS DLC32?

Also, what DIP Switch settings did you make on the MKS DLC32 for the TMC2208?

In what way is the board broken?

They won’t be the same somebody on here told me to change some ? and the settings changed for the TMC 2208 unchanged is X and Y and Z to the bottom like on the diagram…

The broken board i was moving the Entire machine when cleaning up and i thought all cables was out but everyone but the Usb cable like charging port on the phone end ripped out the , I had a new soldered back on but when i plugged it in its saying something like unidentified source …

Do you mean the ribbon cables showing in the picture?
Did they plug right into your steeper motors at the other end?