New to lightburn. I tried a material test and not getting any difference in engrave but a few on the bottom row. I did a side by side comparison with xcs and its a world of difference. Left is LightBurn, right xcs. [IMG_1965]

Ok, well I think we can safely say the issue is with doing design work in inches rather than mm, or at least not changing to mm before sending the job. Thank you for doing the test.

Material Test all the same

LightBurn Software Questions

AshNi (Ashwini) October 18, 2024, 11:20am 5

Hello, @cgarza here is an entire thread dedicated for X Tool S1 users on Lightburn Integration, you should be able to find help here.

Hope this helps