pka4916
(Perry)
February 21, 2025, 11:40pm
1
not sure if this is the right spot, but I am trying to get the paint of a PCB board. but i cannot seem to find the right settings for it…
also importing an svg file, looks terrible.
i tried speed of 600 / 1200 power with 5,10,20 %
uploaded the files on my one drive
20250221_164202.jpg
and the svg
test-B_Cu.svg
what do i need to do, to make it look better?
parsec
(FerAS)
February 22, 2025, 12:23am
2
Congratulations and welcome, glad you found Lightburn and this forum.
Maybe this get what you want:
Read this:
I’m bumping into the known issue of Lightburn not importing my DXFs (created by KiCad) properly. They do however, import correctly into Inkscape. I’ve seen suggestions here to join the paths in Inkscape and re-export them. This doesn’t work for me. I’ve searched and tried everything I could think of. I’ve attached a screenshot of the imported DXF from Inkscape and LB.
I’ve been struggling with for the last four hours (beginning as 3:00 AM). I’m so frustrated I’m ready to throw my computer out t…
Hello and thank for taking the time to review my post. Just bought my first laser cutter which is a Creality Falcon 2. So I am completely new to laser cutting and Lightburn and finding the initiial learning curve steep,
I want to use my laser cutter to help me manufacture prototype printed circuit boards PCBs. The process involves masking the the copper side of the circuit board using spray paint and then using the laser to burn the paint off in selective areas. The board is then chemically et…
system
(system)
Closed
March 24, 2025, 12:23am
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.