Misalainment of output

Hey, I have a MAJOR problem when I am engraving a 1.5 in X 1.75 in area on a receiver for a gun. I can do it successfully on cardboard and then I attach it to the receiver and its off enough to make it not right. I can send photos and settings.

The post you added to was over a year old, for a different laser system, and for a different issue. Best to start a new post when you have a question, so it is not lost at the bottom of an unrelated post. :slight_smile:

When asking questions, we need as much detail as you can provide, so we can “see” what you are experiencing. The following should help,

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.