It is correct we need to short K- & K+ in MKS DLC 32 V2.1.
Now laser tube is firing up and working.
On every stage i am facing a new problem i think that’s called learning.
Now i have three issues.
When machine completed job X and Y Gantry went to home position but Y axis touch with limit switch and on console massage appeared.
2ndly when laser head is at tale of x axis gantry i gave a command to home laser head did not reach at home position and stopped then need to give him again home command and then its properly homed.
during this process there is massage received on console but now i did not remember that words.
What happened to this forum no one is helping me and answering my requested questions.
At least higher management or lightburn staff help me may be other all busy their own life.
If no one help me or reply me then what is purpose of this forum.
We’re here… Every time you add a post, we see movement so we often view that as forward motion. There is a great deal of community engagement on this.
@atif, You have asked multiple questions and it’s hard to tell what the current status of the project is. The community is attempting to help.
I’m going to take the liberty of separating out the leading and trailing edge behaviour in your artwork into a new thread as that is not wiring or firmware related. This does appear to be a software setting and is highly valuable to address clearly.
Let’s keep this thread about firmware for your MKS DLC 32.
Wiring and MKS DLC Configuration files are not really LightBurn related (software) questions but we are sincerely working at helping you enjoy your journey.
