rguertin
February 10, 2026, 5:18pm
1
Has anyone installed the 4 wheel rotary that monport sells.
I have elevated the laser and installed a table into it so I can manipulate up & down movement of the rotary. My problem is that I’m having a problem with the parameters tha have to be se in order for it to work correctly. Any help will be appreciated.
jkwilborn
February 12, 2026, 5:05pm
2
If you read this?
Configuring for a rotary should not be an issue.
I’m assuming you are using the Y axes… you didn’t say…
find steps/rotation
a. identify the switch settings
b. translate from the motor driver placard
steps/rotation is then computed based on a ratio.
a. value entered is steps/rotation multiplied by the ratio which results in the steps/rotation of the wheel, which is what Lightburn needs to know.
This is the basic procedure.
[motor-driver-switches]
Look up the settings on the devices pla…
If you still have problems, sing out.
system
March 14, 2026, 5:05pm
3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
