My image is coming out inverted after it’s been lasered

[berainlb (PY)]

This is a common question for the D1. Check this topic:

New to Lightburn and Laser

I am new to the Technology of Lasers and the software to make them work. I recently purchased an xTool D1 and am using it with mixed success so far. first question. I bought a Grid pattern form Etsy that I would like to set as the default whenever I open Lightburn. I feel like it should be an easy fix I just haven’t found it. I have been opening Lightburn, then opening my grid and importing whatever I am planning to engrave. It’s not very efficient and I found out the hard way that the grid is…