MikeyH
January 14, 2025, 4:04am
2
The Yaxis cable to the stepper motor is unplugged and it connects to the rotary motor. There should be adaptor cords included with the xTool rotary.
You can also search the Forum for information. Here is a little bit to get you started. Use the Forum , it is a goldmine of information.
This is my pretty much completed project for a portable laser workstation. The wood id 1/2" MDF and 2"x2" lumber.
[20230917_135651]
The box floor is 28" wide by 32" deep. Inside height is 18" floor to top. I should have gone with 26" wide because the side panels add an inch, making it a tight fin in a 30" door. The entire box is hinged to lift up giving access to the tool cart tray. The bottom of the cart holds future project materials.
The front and left sides are hinged and have 12"x24" vi…
I now have both a Chuck and a Roller rotary unit. I have done some testing in an effort to make some sense of the needed settings. The Chuck rotary is an xTool RA2 Pro and the Roller rotary is an Atezr KR. Both machines used are the Sculpfun S30 Pro and the SF-A9 (GRBL controllers). Because most rotary units use the same size stepper motor, this information may be relevant to nearly all setups. But no warranty.
I will not get into all the stuff you have to switch when attaching the rotary here.…