NEJE Master 2 (20W) - Unfinisshed shapes

Hello All,

I reported some issue on my NEJE Master 2 (20W), when I tried to print somewhere in paper, the shapes are not finnished, it looks like that laser power goes down before finnish the engraving,

Please see this picture http://science-laboratory.eu/NEJE_LightBurn_Issue.jpg ( circles )
Other settings based on this : https://www.northlakeswoodwork.com/blog/2020/7/5/affordable-laser-engraving-lightburn-setup-for-neje-master-2

This issue is common to diff. speed settings (Tested: 10/15/20mm/s / 60/70/80%)
Do You know what can be solved this issue ? Some settings in lightburn ?

Thanks
Martin

You have focus, mechanical and electronic issues, by the looks.

Start with the mechanical - get it running smoothly and reliably. all mounts and screws firm. then check all your electronic connections. You can put a dab of hot glue or silicon on the connectors to firm them up.

Then, when it’s moving smoothly and reliably, get the focus right.

OK thanks, I will doublecheck.

Hello,

It looks like that I have simillar issue as described there (Ortur LM2 20W Skipping Line Sections) .On dark material burning good.

So, the issue was a focus mainly.

Thanks

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.