New setup of TLC Rotary spins and spins does not complete simple rectangle

[jkwilborn (Jack Wilborn)]

I am not that familiar with the Cohesion, as far as I knew it was a grbl controller. I think you can change some of it via a script. Your settings might be elsewhere…

Might check out this thread, as the lightburn people have referred others to it…

I can't get the laser to change according to the graphic. My power never changes

I just installed a cohesion 3D board which came with smoothieware. I am using Lightburn to drive the laser. Hope this helps. All the latest versions as far as I know. Everything seems to work with the exception of the power settings. It will only use the power set on my K40 digital control. Thanks