Not cutting to pattern

[ednisley]

@Tjhen

Needs to be the square not a triangle

Ah! The Xtool G-Code triangle glitch rises from the grave:

Triangles instead of squares

Good morning everyone, I recently purchased a new 20W XTOOL s1 laser engraver and I encountered a problem while testing the materials: instead of cutting squares, as per the preview, it cuts triangles [20231220_192253] If this anomaly were limited to testing only it would not be a problem, unfortunately this also happens during project processing [20231220_190431] I noticed that this anomaly occurs when the cut feature is after the fill feature. If I do the cutting first and then the fil…

I don’t know what the current status of that mess might be, but newer / better firmware seems appropriate.