OK, Scaling problems in burned image(Image is 2x larger than initial design)

[killrob (roberto ceccherini)]

Read also this post, i think you have similar problem

Correct work space, (X,Y) parameters with Ortur LM Pro 2

Total newbie at this Laser etching/engraving thing, so bare with me as I try to explain what’s going on. Been fighting with the settings and constantly getting the out of bounds error message. For the Ortur LM Pro 2 it has the 400mm x 400mm work space, but it appears the Lightburn settings thinks it half that size, even though it shows 400x400 as the work space in the program. What I had to do was scale down by half the image to get it to work properly. My thinking there is probably a setti…