Omtech ruida alignment issue

[jkwilborn (Jack Wilborn)]

@Shlick1

Then I reset the controller in between runs and it worked perfectly

Sounds like that fixed it?

The home function only sends the head to the home position that the controller set on boot.

A reset is like a power cycle.

See if this is an issue. The name is odd but read through it on the rising and falling edges of the stepper pulse…

How do I fix skewed or slanted engraving?

This is an example of a fill followed by a cut around the letter A: [image] The fill is slanted, but the cut appears to be correct. If you have engraving that is slanting to one side, but cuts appear correctly, you likely have your motor pulse step polarity set incorrectly. On Ruida controllers, there’s a setting called ‘PWM Rising Edge Valid’ that you can change for each axis that tells the controller whether the rising edge or falling edge of a step pulse is what the motor driver is lookin…

Good luck