Ortur laser, alarm 3 problem

[Chevygasser (Robert Berg)]

I can try a different outlet that uses a other fuse. I had The suctionfan on The same outlet before, moved that. I shall move The computer to a different outlet also.

But my problem is similar to this with The unlocked part in The g-code.

Raster cuts out prematurely at random times

I’m experiencing an issue now where the engraving cuts out at random times. The console says the stream is completed, but really its only 15% to 40% done. This is the first time I have done a graphic pattern at this size but previously I was able to dither etch simple gradients. The settings are the same so I so I am not sure what the issue is. below is the console dialog and attached is my file. Please help. I have ruined a few expensive quartz tubes because of this. I have since switched back…