When starting a new project today I came across a sudden new issue where my overlay image was not the same as my camera image. The image was not even an image from the camera, and the preview on the camera console showed the correct image. I am running a MacBook with Tahoe, and I have restarted nume…

Welcome Brendan. Maybe this thread may help you: [image] "Camera" But no image Community Laser Talk the data loaded from the thumb drive. [LB1] selected import “setting" multiple times. LB is labeling it “camera” when I unplug the USB the label goes away…

Brendan. seems we are in the same boat. Im on a new 1Laser (many Thunder components). We are both using Mac/Tahoe. I get the goofy image on the overlay when I select the factory cam calibration that came with the laser. If I start setup as uncalibrated I can get fairly close but not good enough to u…

Tried everything and no luck, Lightburn has not been a help either

Bummer like I said my other laser camera works fine in light burn. I think we have faulty cameras I’m going to duct tape an old iPhone to the underneath side of the lid and see if I can get it to fly. If I have any success, I will post it.

I have tried many experiments on this 1laser/thunder unit. the camera is mounted just 180mm above the honeycomb bed. If its a LB camera (dosen’t appear to be) thats WAY to close to be accurate. I’m in communication with 1laser and they are pondering it. Like my truck, once you get used to that backu…

As of this morning. well well. [Screenshot 2026-04-16 at 9.00.48 AM]

Overlay image is not the same as camera image

LightBurn Software Questions

parsec (FerAS) March 25, 2026, 9:04pm 2

Welcome Brendan.
Maybe this thread may help you: