Pen Up on grbl with a M3S200 command

I already read a lot about pen info. I have made a DIY plotter. I use a mac. My controller is an Arduino Uno. My pen up/down servo is connected with pin 11. I have to give the command M3S200 for a pen up and M5 for pen down. Is the M3S200 possible with Lightburn?

You may want to join the existing very similar Topic here:

Hi, how did you got the M3S90?

I’m suggesting that you go to the other Topic and post there as there is existing dialogue.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.