Photo engraving help

[Rick (Technical Evangelist)]

@LightBurn

Engraving photo-realistic images is one of the cooler things lasers can do, but it’s harder than most people realize.

This might help as well:

Image engraving guidelines

Engraving photo-realistic images is one of the cooler things lasers can do, but it’s harder than most people realize. The key things people get wrong when engraving images are: Going too fast Setting the DPI too high There are three types of Lasers generally supported by LightBurn Glass tube CO2 lasers RF excited CO2 lasers Diode lasers The first, glass tube CO2, uses gas excited by high-voltage power, almost like a neon tube. When the controller tells the laser to fire, it sends a signal…