Ok I don’t know where to put this or how to ask this properly I’m sure. I am trying to etch picture frames and it’s taking forever. The head goes left right left right. I would like it to go up, left, down, right in a circle. I think it would cut faster. I’m not sure but I would like to try is there a way to do this? I know in the 3d printer world it’s called vase mode. But I can’t seem to find that in the settings. Any help would rock thanks
There isn’t a way to do this automatically. If the job is vectors you can split it in half easily enough with the boolean tools, and then just run both parts.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.