Position frame with laser on at 0.25%

[jojo1 (joël Debrue)]

Hello, this is my problem. I know how to turn on the laser to adjust the point.But when I make a frame or a circle in the laser window, the point goes out.
How to make the positioning frame with the laser on at 0.25% .Thanks

[Bonjour (Bo)]

Add a $3 laser pointer.

[LightBurn (Oz)]

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …