Hi there,
I’ve done a bit of research but I don’t have a laser yet, I finalizing my order from Acctek and I would like advice for a power supply. I’ve read that some power supply have a rise time of 15 ms and other 1 ms.
A slow rise time of 15 ms could be an issue for engraving.
Does LightBurn compensate for such a delay? Or is anyone would advice a specific power supply?
I’m planning to order a dual tube 60W and 130w laser Acctek AKJ1390 Chinese Laser with ruida controller.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.