Problem feedrat

Hello, I use lightburn for a laser cutter 40w firmware Marlin card ramps 1.4, my problem is that the movement between two pieces and very slow, about 10mm / s despite a setting at 500mm / s. The faster I cut, the faster it moves … do you have an idea to help me? thank you in advance

Have a look at this previous post found using the forum search:

Marlin doesn’t interpret G0 and G1 moves differently, so you have to use the “Fast Whitespace Scan” device setting to change the movement speed for G0 moves.


OK. Cela fonctionne parfaitement. Merci beaucoup

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.